Routerstation - 3 LAN, 3 MiniPCI, USB2, 680MHZ 64MB 16MB
Performance
- Featuring a fast 680MHz MIPS 24K CPU, 64MB RAM, and 16MB Flash; RouterStation provides a excellent horsepower for a variety of processor intensive multi-radio system applications.
Additional Features:
- Up to 3 mini-PCI radios, 3 10/100 ethernet interfaces, a 5A power supply for multiple hi-power card support, USB 2.0, and enhanced temperature operating performance and ethernet ESD protection for carrier applications.
. Over all system configuration
- CPU Atheros AR7161 MIPS 24K running @ 680MHz
- MEMORY DDR 64MB
- FLASH SPI 16MB
- Three MINI-PCI Slots supports Type IIIA
- One USB 2.0 Host
- One UART
2. Power Supply Range 12VDC to 24VDC
- Using Higher voltage is recommended since it will use lower current
- Typical Power Consumption is 3W idle no radios present
- 5W idle One Radio present
- 7W while passing 100Mbps traffic
- Single RJ45 "J1" Is for WAN and Passive Power Over Ethernet
3. Ethernet Interface
- J1 Single WAN port 10/100
- J2 Dual Lan Port 10/100
- Ethernet Phy switch, ADMTEK "Infineon" ADM6996FC
4. Supported IO
UART J3 6 pin Header
Terminal Settings 115200 baud, 8 bits, nor parity, 1 stop bit.
| Pin Out |
|
| Pin1 |
3.3VDC |
| Pin2 |
S_in |
| Pin3 |
NC |
| Pin4 |
NC |
| Pin5 |
S_out |
| Pin6 |
GND |
USB 2.0 Host J7
5 Pin Header typical PC USB header
| Pin Out |
|
| Pin1 |
5VDC |
| Pin2 |
D- |
| Pin3 |
D+ |
| Pin4 |
GND |
| Pin5 |
GND |
JTAG Port "J4"
14 Pin header
| Pin Out |
|
|
|
| Pin1 |
TRST |
Pin2 |
GND |
| Pin3 |
TDI |
Pin4 |
GND |
| Pin5 |
TDO |
Pin6 |
GND |
| Pin7 |
TMS |
Pin8 |
GND |
| Pin9 |
TCK |
Pin10 |
GND |
| Pin11 |
RST |
Pin12 |
NC |
| Pin13 |
NC |
Pin14 |
3.3VDC |
USER GPIO Header "J33"
Single Row 7 Pin Header Also next to it J5 dual row header to enable pull-up or pull-down for each GPIO user selectable in case User needs Active Low or Active High GPIO
J33 Pin out and Strapping option "place shunt to enable strapping option"
| Pin Out |
NAME |
J5 STRAPPING |
| Pin1 |
GPIO_0 |
PULL LOW |
| Pin2 |
GPIO_1 |
PULL LOW |
| Pin3 |
GPIO_3 |
PULL LOW |
| Pin4 |
GPIO_4 |
PULL LOW |
| Pin5 |
GPIO_5 |
PULL HIGH |
| Pin6 |
GPIO_6 |
PULL HIGH |
| Pin7 |
GPIO_7 |
PULL HIGH |
5. RESET BUTTON "SW4"
Uses GPIO_8 with weak pull-up, Active Low, for Resting back to factory defaults or multiple functions software dependent.
6. LED INDICATORS
| LED |
NAME |
FUNCTION |
| D29 |
POWER |
3.3VDC |
| D24 |
RF |
RADIO Act |
GPIO_2 |
| DS4 |
WAN |
Link/Act |
| DS13 |
LAN1 |
Link/Act |
| DS12 |
LAN2 |
Link/Act |
|
Follow us on Twitter